PDA

View Full Version : Magnetic calibration

pt17
06-09-2010, 05:38 PM
During magnetic calibraton of IIVSGV (v2.27) when "turning west" A/P agressively starts rolling left and right and requires disconnect. For the rest of the cal, (Nth,East and South) it works OK. I have repeated the exercise twice with same result. The A/P performs OK in all other respects including coupling with AFS and GPS. I am unable to complete the cal. Any ideas?
TrutrakTech
06-10-2010, 09:38 AM
It sounds like a possible faulty mag cal. There're a couple of components on the board that could cause this issue. If you want to send it to us, just let me know and I'll give you an RMA number. It only uses the magnetometer in the case of GPS signal loss. Thanks!
stevebucknor1
12-30-2010, 01:44 AM
It sounds like a possible faulty mag cal. There're a couple of components on the board that could cause this issue. If you want to send it to us, just let me know and I'll give you an RMA number. It only uses the magnetometer in the case of GPS signal loss. Thanks a lot.